Pump-solutions-group Neptune GLYCOL FEED SYSTEM Specs Manuel d'utilisateur télécharger pdf

NEPTUNE SPECIFICATION FOR GENERAL USE

Glycol Feed System

I. General – Provide a completely, preassembled package Glycol Feed System

as manufactured by Neptune Chemical Pump Company.

II. Pump – The pump shall be a bronze rotary gear pump with a capacity of 1.5

g.p.m. at a pressure of 100 p.s.i. (optional 3 g.p.m. at 100 p.s.i.). Pump

shall be mounted below the tank.

III. Tank – The tank shall be constructed of polyethylene and be provided with a

four-leg carbon steel stand with four bolt pads. The tank stand shall have

upper and lower steel support banding to insure tank stability. Tank stand

shall be painted with a two-coat system consisting of an oxide primer and

alkyd enamel finish.

IV. Piping – Pump suction piping shall be piped using PVC fittings and tubing.

A PVC ball valve and a cast iron “Y” strainer shall be provided in the pump

suction piping.

Pump discharge manifold shall be piped using Schedule 40 brass fittings

suitable for chilled or hot water service. A pressure switch, ball valve, brass

check valve and brass relief valve shall be mounted on the pump discharge

assembly manifold. Piping shall be supported at both the top and

bottom of the tank frame. The brass relief valve shall be piped back to the

tank using PVC tubing and fittings. A pressure gauge shall be mounted in

the discharge piping.

V. Panel – A 115 volt control panel with NEMA 4X enclosure consisting of the

following shall be provided:

- H-O-A selector switch with running light and magnetic starter for feed

pump. In AUTO, the pump is operated by the skid-mounted

differential (adjustable) pressure switch and interlocked to a low level

float switch mounted in the side of the tank. Level switch also

energizes a low level (optional) audible alarm with silence push button

for alarm acknowledgement. Panel shall also be equipped with an 8’

power cord with grounded plug. Panel shall be mounted to the tank

frame and positioned at eye level for ease of operation. Panels

mounted on tank lids or mounted below the tank are unacceptable.

All electrical components (pressure switch, level switch, and pump)

shall be wired in conduit to control panel. Loose, exposed,

unprotected wire is unacceptable.

Page 1

NEPTUNE SPECIFICATION FOR GENERAL USEGlycol Feed SystemI. General – Provide a completely, preassembled package Glycol Feed Systemas manufactured by

Pas de commentaire

Pump-solutions-group Neptune GLYCOL FEED SYSTEM Specs Manuel d'utilisateur