Pump-solutions-group Neptune Series 6000 dia-PUMP MODELS 6100 thru 6250 Manuel d'utilisateur

ZL107602 for NEPTUNE SERIES 6000 “dia-PUMP” MODELS 6100 thru 6250  Lansdale, PA. 19446

10 Take out Relief Valve cap to access Relief Valve screw (#32 on Parts Drawing). Insert Hex wrench to adjust relief valve setting. FIGURE 2

11 6.0 START UP PROCEDURE The following start up procedure is complete and does repeat instructions on filling the gearbox and pump. 6.0.1 Remov

12 SECTION III NORMAL MAINTENANCE 7.0 MAINTENANCE Under normal conditions, the “dia-Pump” should not require any significant amount of maintenan

13 7.1.5 Remove sealing nut (#39 on Parts Drawing) 7.1.6 Remove seal plate (#38 on Parts Drawing) using small brass hook to pry loose 7.1.7 Rep

14SECTION V TROUBLE SHOOTING CHART SYMPTOMS CAUSES REMEDIES 1. Pump Motor Will Not Operate. A. Blown Fuse. Check for short circuit or overload

15SECTION VI 9.0.1 SPARE PARTS 9.0.2 Important—When ordering spare parts, please show MODEL NUMBER AND SERIAL NUMBER of pump for which parts are b

16

17PARTS LIST FOR PUMP MODELS 6100 to 6250 (REFER TO PART DRAWING ON PAGE 16) PARTS FOR PUMPS WITH METAL HEADS ITEM# DESCRIPTIO

18SECTION VII SPECIAL INSTRUCTIONS FOR SERIES 6000 “dia-PUMPS” WITH ELECTRONIC STROKE CONTROL MODEL #SM-1020 Neptune Electronic Stroke Control U

19

2 WARNING LOCKOUTS ARE REQUIRED BEFORE SERVICING THIS EQUIPMENT. SAFETY INSTRUCTIONS: Shut off/Lockout pump P

20

21SECTION IX DOUBLE DIAPHRAGM OPTION Special Instructions for Series 6000 “dia-Pumps” with Double Diaphragm The instructions below are for Neptun

22 11.0.9 Remove the vacuum pump. Plug valve Item No. 5 with a 316SS pipe plug Item No. 12 (Figure 5) 11.0.10 Reinstall the Pump 11.0.11 Follow

23 MSDS SECTION I - Material Identity Item Name... HYDRALIC LUBRICATING FLUID Part Number/Trade Name...

24 SECTION IV - Fire and Explosion Hazard Data Flash Point Method... UNK Lower Explosion Limit... 1% Upper Expl

25 SECTION VIII - Control Measures Respiratory Protection... NONE NEEDED UNDER ANTICIPATED USE W/ADEQUATE VENTILATION Ventilation..

26NOTES:

27

3 TABLE OF CONTENTS SECTION PARAGRAPH PAGE I GENERAL DESCRIPTION 4 LIMITED WARRANTY 5 PARTS ORDERING INSTRUCTIONS 6

4 SECTION I GENERAL DESCRIPTION The Neptune Series 6000 “dia-PUMP” is a reliable metering pump of the high-pressure diaphragm type. Under con

5 SECTION I NEPTUNE CHEMICAL PUMP COMPANY LIMITED WARRANTY All Neptune Pumps are tested at the factory prior to shipment. Each part used in thei

6 SECTION I PARTS ORDERING INSTRUCTIONS The complete model number and serial number of the pump must be furnished to insure prompt and accurate p

7 SECTION II INSTALLATION INSTRUCTIONS 1.0 GENERAL (REFER TO PARTS DRAWING ON PAGE#16) 1.0.1 UNPACKING & INSPECTION When unpacking a pump

81.0.8 Fill gearbox and pump by pouring the hydraulic fluid (drive lubricant) supplied through the fill opening at the rear of the pump. Pour fluid

94.0.2 The internal relief valve is designed to protect the pump itself should a discharge pressure beyond the relief valve setting o