Pump-solutions-group Neptune Polymaster Liquid Polymer Blend & Feed Manuel d'utilisateur télécharger pdf (Page 14)

START-UP

1. Apply power to the unit by turning the switch at the top right of the unit to “LOCAL”. The red “ON”

light should come on. Since water has not yet been turned on, expect the amber “FAULT” light to

illuminate immediately. This is normal when there is no water flow. The system requires a minimum

of 25 psi applied back pressure to sustain the Run mode otherwise the amber “FAULT” light will

come on.

2. Allow water to flow into the system. Turn the water flow to maximum. Water flow is controlled by the

control knob at the bottom of the flowmeter. All units include a NEMA 4X solenoid valve (normally

closed) which will not allow water to flow until the system is turned on.

3. Check for water leaks at all connections within and attached to the system. Tighten the

connections, if necessary.

4. Prime the polymer feed pump until polymer is drawn to the pump outlet or bleed port using the priming

kit hand pump furnished with the unit. Continue the water flow at maximum while priming and

starting up the polymer feed pump.

(Priming process may vary slightly, see pump manufacturer’s recommended procedure). For

installations that are especially difficult to prime, a hand operated vacuum pump has been included to

assist the polymer feed pump in initially pulling in the polymer.

5. Turn the polymer pump to the desired setting. ADJUST PUMP ONLY WHEN THE PUMP IS

RUNNING. RECOMMENDED OPERATION IS TO SELECT THE CONVENIENT STROKE

LENGTH SETTING AND MAKE ALL FURTHER ADJUSTMENTS, EITHER AUTOMATIC OR

MANUAL, BY SPEED CONTROL.

6. Now lower the water flow to the desired level. At no time do you wish to create a situation

where there is too much polymer and too little water or gelling can occur.

7. Check for polymer leaks at all connections within and attached to the system. Check of air leaks

in the pump suction piping. Tighten the connections, if necessary.

8. The system is now fully operational. Initial settings for desired dilution water and polymer flow rates

have been made. Proceed to fine tune, depending upon the amount of polymer and desired dilution

required and the performance of your process.

NOTE: The system must be calibrated to assure accurate polymer flow rates with the specific

polymer and polymer feed setup used. Calibration instructions begin on page 11. .

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 33 34

Pas de commentaire

Pump-solutions-group Neptune Polymaster Liquid Polymer Blend & Feed Manuel d'utilisateur Page 14